1. ENGINE CONTROL BAR
2. SUPERIOR HANDLE
3. INFERIOR HANDLE
4. ENGINE
5. CARTER
6. WHEEL
7. RECOIL STARTER
8. ADJUST HANDLE
TECHNICAL DATA
CODE
DISPLACEMENT
CUTTING DIAMETER
WHEEL DIAMETER
TANK CAPACITY
HEIGHT CONTROL
POWER
SPEED
WEIGHT
CODE
DISPLACEMENT
CUTTING DIAMETER
WHEEL DIAMETER
TANK CAPACITY
HEIGHT CONTROL
POWER
SPEED
WEIGHT
ASSEMBLY INSTRUCTIONS
ASSEMBLY
NOTE: This unit is shipped without gasoline or
9
PP520A
141 cc
20"(510 mm)
7" / 7"
1,3 L
3 LEVELS
2,5 kW
2 800 r/min
23 kg (50,7 lb)
PP620A
161 cc
20"(510 mm)
7" / 11"
1,3 L
5 LEVELS
3,0 kW
2 800 r/min
27 kg (59,5 lb)
oil in the engine. Fill up with gasoline and oil as
instructed in the accompanying engine manual
BEFORE operating your mower.
ASSEMBLING THE HANDLE
1. Fasten the lower handle to
The device by using two blots and
two small knobs on each side.
2. Unfold the upper handle and fix it to lower
handle
By using the big knobs and the blots on each
side
NOTE: Make sure the rope guide is on the right
handle, when you stand behind the mower.
ADJUSTMENT
SETTING THE CUTTING HEIGHT
WARNING!:
Adjust the cutting height only
When the engine is switch off the spark plug
Boot has been pulled.
The cutting height is centrally adjusted with
Cutting height adjusting handle. Different
cutting Heights can be selected.
Pull the adjusting handle out and select the
Desired cutting height. The handle snaps
Into the desired position.
From position 1 to position 7 . The cutting
height Range from 25mm to 75 mm
OPERATION INSTRUCTIONS
GAS AND OIL FILL-UP
Refer to the separate engine owner's manual
for additional engine information.
1. Add oil provided before starting unit for the
first time out of the box.
2. Service the engine with gasoline as instructed
in the separate engine owner's manual.
WARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable and
the vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
Before using the machine you must read the
engine instruction book.
Engine delivered without oil: add 0.6 liter of oil
before starting the engine.
ENGINE STARTING:
Once the machine has been set up properly,
start the engine as follow: