Connections To Be Made - Axxess AXVI-1731 Manual Del Usuario

From the AXVI-1731 harness to the aftermarket radio:
• Connect the Black wire to chassis ground, and also to the Black wire of the AXCSD-6V.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the vehicle is equipped with a factory backup camera:
• Connect the Red wire labeled "6-volt camera" to the AXCSD-6V.
• Connect the Yellow RCA jack to the backup camera input.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
2

CONNECTIONS TO BE MADE

The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
AXCSD-6V 12-volt to 6-volt converter:
• Connect the Blue/Red wire to the Red wire labeled "Camera Power 6V".
• Connect the Blue/White wire to the Green/Purple wire.
12-pin pre-wired AXSWC harness:
• This harness is to be used along with the optional AXSWC (not included) to retain steering
• Connect the Red wire to the accessory wire.
Note: Before connecting this wire, also refer to the "AXCSD-6V 12-volt to 6-volt" converter
section.
Note: The Green/Purple wire will connect to both the AXCSD-6V, and the aftermarket radio.
wheel audio controls. If the AXSWC is not being used, disregard this harness. If it will be
used, please refer to the AXSWC instructions for radio connections and programming.
Note: Disregard the harness that comes with the AXSWC.