Troubleshooting - Black+Decker FSMH1300FX Manual De Instrucciones

ENGLISH
After use
Turn the Autoselect dial (2) to the OFF position.
TM
u
Wait until the steam mop cools down.
u
Unplug the steam mop from the electrical wall outlet.
u
Empty the water tank.
u
remove the cleaning pad (10) and wash it ready for next
u
use (take care to follow the wash care instructions printed
on the cleaning pad).
Accessories
The performance of your appliance depends on the accessory
used. BLACK+DECKER accessories are engineered to high
quality standards and designed to enhance the performance
of your appliance. By using these accessories you will get the
very best from your equipment.
Hand held steam cleaning
Warning! ! Maintain the unit in a horizontal position during
use.
Attach the required accessory.
u
Connect the hand held steam cleaner to the mains.
u
Press the ON/OFF button (1). It takes approximately 15
u
seconds for the steam mop to heat up.
Turn the Autoselect dial (2) until the required setting is
TM
u
reached. After a few seconds steam will start to come out
of the steam head.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
When you have finished using the hand held steam
u
cleaner turn the Autoselect
Turn the unit OFF by pressing the ON/OFF button (1) and
disconnect from the mains supply. Wait until the unit cools
down before storing (approximately five minutes).
Technical Data
Voltage V
ac
Power
W
Tank
ml
Capacity
Weight
kg

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem Step
The steam mop is not 1.
turning on
2.
3.
10
(Original instructions)
dial (2) to the OFF position.
TM
FSMH1300FX Type 2
230
1300
500
Possible solution
Check the unit is plugged in at the wall
socket.
Check the unit is switched on using the
ON/OFF switch (1)
Check the fuse in the plug.
(Übersetzung der ursprünglichen
Problem
The steam mop is not
producing steam
The steam mop stops
producing steam
during use
The steam mop is
producing too much
steam during use
The steam mop is
producing too little
steam during use
Where can I get further
information/
accessories
(Übersetzung der ursprünglichen
Verwendungszweck
Your BLACK+DECKER
wurde zum hygienischen Säubern von Bodenbelägen
aus versiegeltem Hartholz, Laminat, Linoleum, PVC,
Keramikfliesen, Stein und Marmor entwickelt. Dieses Gerät
darf nur im Innenbereich verwendet werden und ist nicht für
den gewerblichen Einsatz vorgesehen.
Sicherheitshinweise
Warnung! Lesen Sie alle
Sicherheitswarnhinweise
und alle Anweisungen
Nichteinhaltung der folgenden
Warnungen und Anweisungen
kann einen elektrischen Schlag,
Brand und/oder schwere Verlet-
2.4 zungen verursachen.
@
Warnung! Beachten Sie beim
Umgang mit netzstrombetrie-
benen Geräten stets die grundlegenden
Sicherheitshinweise, die im Folgenden
beschrieben werden. Dadurch verhindern
Sie Brände, Stromschläge sowie Sach-
und Personenschäden.
DEUTSCH
Anweisungen)
Step Possible solution
4. The steam mop will only produce steam if
the hand held steam cleaner (5) is
correctly docked into the main body (11)
or the steam hose is fitted or the
Autoselect is turned to ON
TM
Check that the water tank is full. Note:
5.
When first filled or after running dry it can
take up to 45 seconds for steam to be
produced.
6. Check steps 1, then 2, then 3
7. Check steps 4, then 5, then 3
8. Turn the Autoselect dial (2)
TM
anti-clockwise to reduce the amount of
steam being produced
9. Turn the Autoselect dial (2) clockwise to
TM
increase the amount of steam being
produced
10. www.blackanddecker.co.uk/steammop
www.blackanddecker.ie/steammop
DEUTSCH
Anweisungen)
Dampfreiniger FSMH1300FX
TM
. Die