Set-Up; Installing The Unit - Oase biOrb EARTH Manual De Instrucciones

Operating conditions indicated by the LED (15)
LED status
Green Continuous light
Flashing
Red Continuous light
Flashing
Blue Continuous light
Flashing
Off
Button functions (15)
Usage
Press briefly
Hold for 5 seconds
Hold for 15 seconds

Set-up

Installing the unit

Position the biOrb EARTH on a sufficiently large, load-bearing surface, for instance on a table or
on a cabinet.
NOTE
Protect the unit from direct sunlight.

 Ensure that an electrical outlet is in the immediate vicinity.
 Do not cover the ventilation openings of the unit.
Air at a temperature of up to 55 °C can exit the ventilation openings on the sides and cause

damage to plants or other heat-sensitive materials. Ensure sufficient clear space.
 Ensure that there is sufficient space to access the unit.
Description
biOrb EARTH is operating and has a network connection.
biOrb EARTH is operating and is looking for a network connection.
biOrb EARTH is starting (boot phase) or being reset.
Malfunction pending; possibly ...
• the cover is not positioned correctly.
• the target temperature or the target humidity have not been
reached.
biOrb EARTH is in delivery condition and is waiting for configuration via
the "OASE Control" app.
Liquid reservoir empty.
biOrb EARTH is switched off.
Description
Reset "Liquid reservoir empty" message. (The LED stops flashing in
blue.)
Reset network connection. A signal is audible at the end.
Reset biOrb EARTH and app to factory settings. Three signals are audi-
ble at the end.
EN
13