UFO
Transmodulator QPSK-QAM
UFO 386/TP QPSK/QAM to plug into UFO
and extension units UFG 3xx.
Features :
■ For conversion of SAT/QPSK signals into cable/QAM-signals
in accordance with DVB standard in frequencies ranging
from 110 MHz to 862 MHz
■ Adjacent channel compatible
■ MPEG2 transport stream processing:
– constant output symbol rate (stuffing) can be set
– programme filter
– cable NIT (control bus demultiplexer UFX 312 required)
– CAT processing (PC software USW 30 required)
■ Output level is adjustable via the control unit
■ Output signal disengageable via the control unit
■
■ Accessories :
Sticker for explanatory notes
Technical data
Type
Frequency
Order no.
Input
1
)
UFO 386/TP
950-2150
MHz
20610014
1} Adjustable in 1 MHz steps
2) Adjustable in the 8 MHz channel plan or in 250 kHz steps in the output channel which was set.
3) Input level at channel unit. For system planning, observe distribution loss (see base and extension units).
4) Level adjustment range : 0 to –10 dB
5) Error protection in compliance with DVB-Standard, code rate is automatically determined. Only partially SCPC compatible.
6) The output symbol rate is automatically determined depending on the input signal (symbol rate, code rate). The output symbol rate can be set
in operation mode "Stuffing", provided that the rate is higher than the symbol rate automatically determined.
Recommended adjustment > 2,000 MS/s.
®
compact Processing System
®
compact base
Level/Impedance
Output
2
)
Input
3
)
Output
110-862
45-80
Max.
MHz
dBµV
85 dBµV
75 Ω
75 Ω
Modulation
4
)
Input
Output
SAT-
16/32/64/
QPSK
128/256
QAM
UFO 386/TP
20610014
Output
(F connector, female)
Place for
supplied sticker
Connector for
control unit (Mini-DIN)
Connection for
power supply bus
Sat IF input B
(F connector, female)
Sat IF input A
(F connector, female)
Symbol rate
Supply voltage/
Input
5
)
Output
6
)
1,500 –
7,150 MS/s,
12,5 V / 450 mA
2–35 MS/s
automatic
or
adjustable
power
consumption
5 V / 400 mA
31 V / 7 mA
1