Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Settings for cable NIT
A B C D E F G H I J K L M N O P Q R S
T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 _
KATHREIN WERKE KG_
Submenu name
The network ID must only be set if the operator applied for it at ETSI and after it was granted.
The present value (FF01) is for networks without special ID.
Network ID setting should only be effected by adding "+" or taking away "–" signs from the third (name) line with the
flashing cursor. The maximum number of signs is 40. The selection of the sign to be added is effected in the first two lines
with the keys "<" ">" withe cursor movement.
The network ID is to be entered digit by digit with the (< >) keys and changed with the (+) or (–) keys.
The value is taken over on exit from the submenu by pressing the
Building up of the cable NIT, submenu
* * * *
Cable NIT
NIT
ON
Network
Name
<
Return:
Submenu cable NIT
After the building procedure was manually started with the key "+", the control unit takes over the complete NIT
build-up. The new cable NIT will be established and then transmitted to the TP channel units (UFO 386/ TP). Truncation
of the procedure is possible with the rhomboid key
during the build-up period.
The generated cable NIT can be switched on or off as needed.
Display in case of truncation :
NIT error:
Operator truncation
< Continue:
Submenu Cable NIT
Requirements for a successful build-up of NIT:
●
Installation of the reception system must have been fully completed.
●
The reception system must have been fully adjusted.
All TP channel units must be operational and locked in place.
●
Network ID:
* * * *
Build up
ID
❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚
Submenu >
. A band display will be shown in the lower line of the display
Switching on the cable NIT:
* * * *
NIT
network
key
>
< Continue:
Submenu ID
key.
Cable NIT is
being built up
please wait
....
Submenu cable NIT
Cable NIT
Submenu Cable NIT
F F 0 1
* * * *
ON
Build up
Name
ID
key
>
13
Publicidad
Tabla de contenido
