Digital Signal Processor
Using balance adjustment
You can select a fader/balance setting that
provides an ideal listening environment in all
occupied seats.
1
Press p to select Fad.
Press p until Fad appears in the display.
# If the balance setting has been previously ad-
justed, Bal will be displayed.
2
Press r or q to adjust front/rear
speaker balance.
Each press of r or q moves the front/rear
speaker balance towards the front or the rear.
Fad :F25 Fad :R25 is displayed as the front/
rear speaker balance moves from front to rear.
# Fad : 0 is the proper setting when only two
speakers are used.
3
Press m or n to adjust left/right
speaker balance.
When you press m or n, Bal : 0 is dis-
played. Each press of m or n moves the
left/right speaker balance towards the left or
the right.
Bal :L25 Bal :R25 is displayed as the left/
right speaker balance moves from left to
right.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
1
Press p to select SLA.
Press p until SLA appears in the display.
2
Press r or q to adjust the source vo-
lume.
Each press of r or q increases or de-
creases the source volume.
All manuals and user guides at all-guides.com
SLA +4 SLA 4 is displayed as the source vo-
lume is increased or decreased.
! Video CD and CD are set to the same source
! Analog4, Analog5 and Analog6 are set to
Using the dynamic range
control
The dynamic range refers to the difference be-
tween the largest and softest sounds. The dy-
namic range control compresses this
difference so that you can clearly hear sounds
even at low volume levels.
! The dynamic range control is effective only
1
Press p until DRC appears in the display.
# When playing other than the DVD disc, you
cannot switch this mode.
2
control on.
DRC ON appears in the display. Dynamic
range control is now on.
# To turn dynamic range control off, press
q.
Notes
level adjustment volume automatically.
the same source level adjustment volume
automatically.
on Dolby Digital sounds.
Press p to select DRC.
Press r to turn the dynamic range
Section
07
21
En