Selecting A Cut-Off Frequency; Adjusting The Speaker Output Levels; Adjusting The Speaker Output Levels Using A Test Tone - Pioneer AXM-P7050 Manual De Operación

Section
07
Digital Signal Processor

Selecting a cut-off frequency

You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro-
duced through a LARGE speaker or subwoo-
fer.
1 Press p and hold until SP Set appears
in the display, then press p to select
CutOff.
After SP Set is displayed, press p until
CutOff appears in the display.
2 Press m or n to select cut-off fre-
quency.
Each press of m or n selects cut-off fre-
quencies in the following order:
6380100125160200 (Hz)
3 Press BAND to return to the playback
display.
Note
Selecting a cut-off frequency is to set a cut-off fre-
quency of the subwoofers L.P .F. (low-pass filter)
and that of the SMALL speaker H.P.F. (high-pass
filter). The cut-off frequency setting has no effect
if the subwoofer is set to OFF and other speakers
are set to LARGE or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
24
En
All manuals and user guides at all-guides.com
1 Press p and hold until SP Set appears
in the display, then press p to select
SP Lev.
After SP Set is displayed, press p until
SP Lev appears in the display.
2 Press m or n to select the speaker
to be adjusted.
Each press of m or n selects the speaker
in the following order:
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
# You cannot select speakers whose size is set
OFF.
3 Press r or q to adjust the speaker
output level.
Each press of r or q increases or de-
creases the speaker output level. +10  10 is
displayed as the level is increased or de-
creased.
4 Press BAND to return to the playback
display.
Note
To adjust the speaker output levels at this mode is
the same as making the speaker output levels at
T Tone. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Press p and hold until SP Set appears
in the display, then press p to select
T Tone.
After SP Set is displayed, press p until
T Tone appears in the display.