Quick Start Guide
FLASHBACK 2 X4 DELAY
(1)
(2)
(1)
(2)
(3)
(8)
(8)
(EN) Controls
Delay Type – Select delay type, TonePrint 1-6, or
(1)
the looper.
SUBDIV – Select the rhythmic subdivision of the
(2)
beat, or your own custom setting.
DELAY – Adjusts the delay time.
(3)
FEEDBACK – Determines the number of delay repeats.
(4)
BANK/STORE – Press the switch up to toggle
(5)
between presets 1-3 or 4-6. Press the switch down to
store the current settings to the selected preset.
LEVEL – Adjusts the level of the delay repeats.
(6)
MASH LED – Indicates the intensity of
(7)
MASH functionality.
V 2.0
(3)
(4) (5)
(6)
(4) (5)
(6)
(7)
(9)
(9)
Footswitches – Tap to select presets 1-3 or 4-6,
(8)
depending on the Bank 1/2 setting. Press and
hold a footswitch to engage MASH and control the
selected parameter.
TAP – Press in rhythm to enter the delay tempo.
(9)
Also performs undo/redo in looper mode. Press and
hold footswitch to engage MASH and control the
selected parameter.
INPUT – Connect your guitar to the Mono input
(10)
using a standard ¼" instrument cable. If using a
stereo signal, connect the left channel to Mono and
right channel to Stereo.
OUTPUT – Connect a standard ¼" instrument cable
(11)
to the Mono output jack and to the next pedal in
your chain, or to an amplifier. If using a stereo signal,
send the left signal from the Mono jack and the right
signal from the Stereo jack.
(10)
(10)
(11)
(7)
EXP – Connect an optional expression pedal to
(12)
control parameters like delay time or feedback level.
BYPASS – Select between True Bypass or Buffered
(13)
Bypass operation.
KILL DRY – Engage Kill Dry to remove the direct
(14)
signal, sending only the delay signal to the outputs.
POWER – Connect a 9 V / ≥300 mA power supply.
(15)
USB – Connect to a computer for firmware updates
(16)
and TonePrint editing.
MIDI – Connect standard 5-pin DIN cables to
(17)
control preset changes, MASH, potentiometer values,
and more.
(11)
(12) (13) (14) (15) (16)
(12) (13) (14) (15) (16)
(17)
(17)