Hilti SF 18-A Manual De Instrucciones página 19

1. Insert the drill bit in the keyless chuck and then turn the chuck firmly by
hand until several clicks are heard.
2. Check that the drill bit is held securely.
6.5 Removing the drill bit
1. Open the keyless chuck.
2. Pull the insert tool out of the chuck.
6.6 Drilling
CAUTION
Use clamps or a vice to secure the workpiece. The workpiece is thus
held more securely than by hand and both hands remain free to operate
the power tool.
1. Turn the torque and operating mode setting ring to the drilling symbol.
2. Move the forward / reverse switch to the "Forward" position.
6.7 Hammer drilling
1. Turn the torque and operating mode setting ring to the hammer drilling
symbol.
2. Move the forward / reverse switch to the "Forward" position.
6.8 Screwdriving
6.8.1 Fitting the bit holder / bit
1. Open the keyless chuck.
2. Insert the bit adapter in the keyless chuck and then turn the chuck firmly
by hand until tight.
3. Check that the bit adapter is held securely (check by pulling).
4. Fit the bit in the bit holder.
6.8.2 Screwdriving
1. Turn the torque, drilling and hammer drilling setting ring to the required
torque setting.
2. Set the forward / reverse switch to the desired direction of rotation.
6.8.3 Removing the bit / bit holder
1. Remove the bit from the bit holder.
2. Open the keyless chuck.
3. Remove the bit adapter.
Printed: 22.06.2015 | Doc-Nr: PUB / 5226599 / 000 / 01
en
13