Opel 24286903 Instrucciones De Manejo página 2

Part numbers: 24286903 / 24286904
Portable Charge Cord
1. Wall Plug
2. Status Indicators
3. Vehicle Plug
4. Release Button
Important Safety Instructions
This symbol means Warning: Risk of electrical shock.
Important Information about
Portable Electic Vehicle Charging
● Charging an electric vehicle can stress a building's electrical system more than
a typical household appliance.
● Before plugging into any electrical outlet, have a qualified electrician inspect
and verify the electrical system for heavy-duty service at a 12 amp continuous
load.
● Electrical outlets may wear out with normal usage or may be damaged over
time, making them unsuitable for electric vehicle charging.
● Check the electrical outlet/plug while charging and discontinue use if the
electrical outlet/plug is hot, then have the electrical outlet serviced by a qualified
electrician.
● When outdoors, plug into an electrical outlet that is weatherproof.
● Mount the charging cord to reduce strain on the electrical
outlet/plug.
Improper use of portable electric vehicle charge cords may cause a fire,
electrical shock, or burns, and may result in damage to property, serious
injury, or death.
● Do not use extension cords, multi-outlet power strips, splitters, grounding
adaptors, surge protectors, or similar devices.
● Do not use an electrical outlet that is worn or damaged, or will not hold the
plug firmly in place.
● Do not use an electrical outlet that is not properly grounded.
● Do not use an electrical outlet that is on a circuit with other electrical loads.
When using electric products, basic precautions should always be followed,
including the following:
● Read all the safety warnings and instructions before using this product.
Failure to follow the warnings and the instructions may result in electric
shock, fire, and/or serious injury.
● Never leave children unattended near the vehicle while the vehicle is
charging and never allow children to play with the charge cord.
● If the plug provided does not fit the electrical outlet, do not modify the plug.
Arrange for a qualified electrician to inspect the electrical outlet.
● Do not put fingers into the electric vehicle connector.
● To reduce the risk of fire, installations shall comply with the requirements of
National Electric Code, ANSI/NFPA 70 (USA), Canadian Electrical Code CSA
22.1 and IEC 60364 – Electrical installations in buildings, depending on the
region in which the unit is being installed. The installer shall comply with any
additional local requirements mandated by the country and/or municipality.
● Do not use this product if the flexible power cord or the electric vehicle
cable is frayed, has broken insulation, or shows any other signs of damage.
● For Canada only: Not for use in commercial garages.
● Do not use this product if the enclosure or the vehicle plug is broken,
cracked, open, or shows any other indication of damage.
● The plug must be plugged into an appropriate electrical outlet that is
properly installed in accordance with all local codes and ordinances. Do
not modify the plug provided with the product. If the plug does not fit the elec-
trical outlet, have a proper electrical outlet installed by a qualified electrician.
If ground is missing, the charge cord indicators will indicate an electrical
system fault and the vehicle may not charge.
Portable Charge Cord
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EXACTLY AS
SHOWN ON 8.5 x 11 WHITE 16 POUND
26MR15
NON-BOND RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUDING
09NO16
TEMPLATES. TO BE UNITIZED IN
ACCORDANCE WITH GMCCA
22FE17
SPECIFICATIONS.
Check NEW UPDATES
Danger
Warning
Caution
REVISION
Initial Release - Rob Mantinan
Revision - Cheryl Garrison
Revision - Cheryl Garrison
www.ifz-berlin.de
Charge Cord Status Indicators
After plugging in the charge cord, it will perform a quick self test.
Verify the charge cord status. When the
charge cord is ready to charge the vehicle.
The charge cord utilizes a combination of the
the status of the charge cord per the following table.
Off
Solid
(No Light)
Green
Flashing
Solid Red
Green
Off
Solid Red
(No Light)
Off
Flashing
(No Light) Red
Solid Flashing
Green Red
If no status indicators are lit, ensure the electrical outlet is powered.
Charge Limit Selection
Charge level selection can be made using the Charge Limit Preference screen
on the center stack. Refer to "Charge Limit Selection" under Programmable
Charging in the vehicle owner's manual.
Using a charge level that exceeds the electrical circuit or electrical outlet
capacity may start a fire or damage the electrical circuit. Use the lowest
charge level until a qualified electrician inspects the electrical circuit capacity.
Use the lowest charge level if the electrical circuit or electrical outlet capacity
is not known.
Grounding Instructions
This product must be grounded. If this product should malfunction or break
down, grounding provides a path of least resistance for electric current to
reduce the risk of electric
shock. This product is equipped with a cord that has an equipment grounding
conductor and a grounding plug. The plug must be plugged into an appropriate
outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
Improper connection of the charge cord ground may cause electrical shock.
Check with a qualified electrician if there is doubt as to whether the product
is properly grounded. Do not modify the plug provided with the product. If it
will not fit the electrical outlet, have a proper electrical outlet installed by a
qualified electrician.
REV 22FE17
PART NO.
TITLE
AUTH DR
2234084
2552046
23277719
PART NO.
2552046
indicator is lit solid green, the
and
Symbol Fault/Condition/Event
No faults: The charge cord is receiving power
from the electrical outlet and is ready to supply it
to the vehicle.
Electrical Outlet/Plug Fault: The charge cord has
detected that the electrical outlet/plug overheated.
Electrical outlets may wear out with normal usage
or be damaged over time, making them unsuitable
for electric vehicle charging. Do not use an
electrical outlet that is worn, damaged, or one that
will not hold the plug firmly in place. Use another
electrical outlet or have the electrical outlet ser-
viced by a qualified electrician. Reset the charge
cord by unplugging the charge cord from the
electrical outlet and re-plugging it.
Electrical System Fault: The charge cord has
detected a missing or improper ground within the
building's electrical system. Do not use an
electrical outlet that is not properly grounded. Use
another electrical outlet or have a qualified
electrician inspect and verify the building's
electrical system.
Vehicle Fault: The charge cord ground-fault circuit
interrupter (GFCI) has tripped. Ensure that there
is no physical damage to the charge cord, and
that the vehicle plug is seated completely and
making a good connection. Reset the charge
cord by unplugging from the electrical outlet and
re-plugging it. If the fault remains, see an
authorized dealer for service.
Charge Cord Fault: The charge cord has detected
a potential problem with the charge cord. Reset
the charge cord by unplugging from the electrical
outlet and re-plugging it. If the fault remains, see
an authorized dealer for service.
Warning
Warning
23277719
SHEET
Installation Instructions
Portable Charge Cord
24 286 903
24 286 904
indicators to display
1 12
OF
1
12
SHEET OF