Chicco 7389 Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
USE WITH THE CAR PLUG
WARNING: Do not use the bottle warmer in the car when it is in motion as the hot water could
cause burns if it spills.
Before performing the steps illustrated below, make sure the power cord (c) is unplugged from
ng
the car cigarette lighter.
Proceed according to steps 1, 2 and 3 illustrated under USE AT HOME.
or
4. Check that the selector is set to the centre position "O" (OFF) (d1). Pull out the car cigarette lighter
adapter plug (e) from the car plug base/holder (f ), connect it to power cord (c) and plug it into
ody
the car cigarette lighter.
wer
Follow the instructions in steps 5 and 6 of the "USE AT HOME" section.
7. To switch the bottle warmer at any time, shift the selector to the centre position "O" (OFF) (d1)
and disconnect the car cigarette lighter adapter plug (e) from the socket.
8. On removing the bottles and/or baby food jars from the bottle warmer, dry them carefully before
feeding your baby.
WARNING:
Before using the product in the car, always check whether the car cigarette lighter is compatible
with the electrical characteristics of the product.
up
Do not use the product with a 24V car cigarette lighter (e.g., trucks): the product could be ruined
damaged irreversibly and cause the failure of the vehicle's electrical system.
pli-
t is
WARNING:
om
Before feeding your baby, always check the temperature of the contents is not too hot.
per
The car cigarette lighter adaptor (e) runs on a completely different voltage from the one used at
home; the warming times will therefore differ quite considerably.
bly,
es,
MAINTAINING THE TEMPERATURE
m-
At the end of the warming cycle, you will hear 5 short beeps and the green LED will come on,
nce
unless you switch it off (turning the selector knob to "O" (OFF) (d1)), the appliance will keep the
food warm for a maximum of 60 minutes from the start of the cycle; after 60 minutes, the appliance
nd
will switch off automatically.
(a),
WARNING: During the maintenance cycle, the temperature of the food may rise above
37°C. Always check that the temperature of the food is not too hot before feeding your child.
We recommend consuming powdered formula mixed with cold water immediately.
not
NB:
he
- We recommend consuming warmed milk and baby food immediately.
ure
- Milk and baby food must never be warmed again after feeding. If you warmed the milk/baby food
for a previous meal, throw it away.
CLEANING, CARE & MAINTENANCE OF THE APPLIANCE
When you finish using the appliance, always unplug the bottle warmer's power cord (c) plug from
en
the mains socket. Allow the bottle warmer to cool down completely, remove any water left inside
and dry the inside thoroughly; store it in a clean and dry place.
not
DESCALING
During normal use of the appliance, limescale residue may build up inside the water tank which
may
can compromise the performance and damage the appliance over time. To remove the limescale
from the bottom of the tank, check that the bottle warmer is cold, make a 200-ml solution of water
and white vinegar, in equal parts, and pour into the tank; leave to soak overnight.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido