Publicidad
Part no
6159945810
Issue no
0
Series no
B
Date
0
Page
10 / 46
DISASSEMBLY AND REASSEMBLY INSTRUCTIONS
D i s c o n n e c t t h e m a c h i n e f r o m t h e
c o m p r e s s e d a i r s u p p l y . R e m o v e a l l
accessories.
Before disassembling the machine, decompress
the air from the oil tank by loosening and re-
tightening the screw (9).
At each disassembly of the governor, clean the
spring housing, check the condition of the spring
and re-lubricate it carefully.
The governor has a calibrated spring which
can only be replaced by an original spare
part.
At each disassembly of the bevel gear, change the
Nylstop nut (605.57).
Before removing the turbine assembly from
the motor housing, do not forget to remove
the decompression fitting (746.52).
When re-assembling, always position the cylinder
exhaust on the opposite side of the turbine
housing.
1
KA165B
Publicidad
