Led Definitions - Symbol LS1203 Manual De Instrucciones

10
Beeper
Sequence
The power-up
beep occurs
more than once.
RS-232 only
1 short high beep A <BEL> character is

LED Definitions

In addition to beeper sequences, the
scanner communicates with the user using
a two-color LED display. The table below
defines LED colors that display during
scanning.
LED
Off
Green
Red
Programming Bar Codes
Descriptions
This guide includes the programming bar
codes required to set up the scanner to
work with various host interfaces. Some
frequently used programming bar codes
are also included.
For all programming bar codes and detailed
information about the scanner, go to:
http://www.symbol.com/services/manuals
The USB bus may put the
scanner in a state where
power to the scanner is
cycled on and off more
than once. This is normal
and usually happens when
the host PC cold boots.
received and Beep on
<BEL> is enabled.
No power is applied to the scanner,
or the scanner is on and ready to
scan.
A bar code was successfully
decoded.
A data transmission error or
scanner malfunction occurred.
Indication
Indication
LS1203