Care And Cleaning - Hydrofarm Active Air ACFW16HDB Manual De Instrucciones

OPERATION INSTRUCTIONS:
1. Plug the fan into a power outlet. Make sure the your local power's voltage and frequency match
what this fan requires (120V/60 Hz).
2. Pull the switch/speed control string to select the speed. The arrow on the dial points at 0/1/2/3,
which correspond to OFF/LOW speed/MID speed/HIGH speed.
3. Push/pull the fan guard up and down to adjust your desired degree of tilt.

CARE AND CLEANING

Set the switch to OFF and unplug the wall mount fan before cleaning or making repairs.
NOTE: If for any reason this unit requires service, return appliance to manufacturer or a similarly
qualified service agent to ensure safety.
CLEANING
To clean blades: Disconnect the power cord from the socket. Remove the guard and the blades
carefully. Do not drop the blades, as they can easily bend. First use a soft cloth with light soap to
clean off oil stains. Then wipe dry and polish with a dry cloth. Never use abrasive cleaners, solvents,
chemical cleaners or corrosive liquids that will damage the paint, metal or plastic. They may cause
damage or deterioration to the surface of the unit.
• Replace the blades and lock the guard securely before use.
• Clean the fan's other parts using a damp cloth and a mild detergent, if necessary. Make certain all
detergent residue is removed.
• Do not allow water/liquids to drip on or into the wall mount fan motor housing.
MAINTENANCE:
• Make certain the wall mount fan is unplugged. Unlock the metal clips on the front grill and
remove the front grill. Use a Phillips screwdriver to loosen the blade fixing screw and remove the
wall mount fan blade.
• The fan blade and grill may be cleaned with a damp cloth and mild detergent.
• After the cleaned parts have dried completely, reassemble the fan by replacing the fan blade,
tightening the blade fixing screw onto the motor shaft, and securing the front grill. Do not plug
the wall mount fan into an electrical outlet until it is fully reassembled.
INSTRUCTIONS
5