Medline MDS4001 Manual Del Usuario página 16

How to Apply the Arm Cuff
1.Place the cuff directly on your bare upper arm.
2.Adjust the cuff so that the bottom edge lies about 1 inch
above the elbow on the inside of the arm.
3.Align the Artery Mark ( ) over the brachial artery, which
runs down the inner arm. Position the cuff hose straight
down your arm, in line with the middle finger.
4.Pull the end of the cuff and secure it snugly with the
hook and loop closures. You should be able to fit two
fingers between your arm and the cuff.
5.Confirm the indicator at the top, outer edge of the
cuff lies within the fit range (
6.Plug the air tube connector into the socket on the left
side of the monitor.
IMPORTANT: Make sure the cuff hose remains straight along the arm and unkinked during measurement.
Avoid compression and restriction of tubing.
16
).
1 inch
Artery Mark
Index and Proper Fit Range
Air Tube Connector
SYS
mmHg
Brachial Mark
DIA
mmHg
Palm Facing Up