DeWalt DW861 Manual De Instrucciones página 8

E N G L I S H
• To stop the tool in continuous operation, press
the switch briefly and release it. Always switch
OFF the tool when work is finished and before
unplugging.
• Do not switch the tool ON or OFF when
under load.
• Let the cutting wheel come to a complete
standstill before setting the tool down.
Cutting (fig. G)
• Draw a cutting line on the workpiece.
• Align the edge of the base front with the
cutting line.
• Place the base on the workpiece, making sure that
the cutting wheel does not touch the workpiece.
• Switch the tool on and wait for the cutting wheel
to attain full speed.
• Move the tool forward along the cutting line.
To make cuts deeper than 20 mm,
make 2 or more separate shallow cuts
to prevent motor failure.
Wet cutting (fig. F & G)
• Mount the wet cutting system as described
above.
• Turn on the water supply and regulate the water
flow using the control valve (f).
• Proceed as described for normal cutting.
Make sure that no water enters the tool.
Consult your dealer for further information on the
appropriate accessories. Recommended
accessories are shown in fig. I.
en - 4
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Carbon brushes
The carbon brushes are well accessible and can be
replaced easily. The brushes must be checked every
50 hours of operation.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
WALT repair
E
4