Philips Norelco Bodygroom 3000 Serie Manual De Instrucciones página 3

- Always attach power cord to product
first, then to outlet. Be certain plug is
inserted firmly into product up to mark
indicated on plug. To disconnect, turn
product off then remove power cord
from outlet.
- Keep the power cord dry at all times. Do
not handle with wet hands.
- Use only the cord provided to charge the
product.
- Never put the product in direct sunlight
or store at a temperature above 140 °F
(60 °C).
- This product is water-safe and can be
rinsed under running tap water or used in
shower. Do not submerge product in
water.
- To prevent possible damage to the cord,
do not wrap cord around the product.
- This product is for use on human hair
only. Do not use the product for any
other purpose.
- Always store the product, attachments
and power cord in a moisture-free area.
Make sure the cord is disconnected from
the product.
- Do not attempt to open the product to
remove or replace the built-in
rechargeable battery.
- Only use the power plug and other
accessories supplied with the product.
SAVE THESE INSTRUCTIONS
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug
to replace it with another plug as this will
cause a hazardous condition.
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that
Philips Norelco offers, register your product
at www.norelco.com/register.
General description (Fig. 1)
1 Trimming guard (3mm/ 1/8in.)
2 Shaving unit
3 Shaving foil
4 On/off button
5 Battery status indicator
6 Back shaving attachment
7 Power plug
8 Small plug
This symbol indicates that the product can
be used in the bath or shower.
Charging
Battery status indications
- When the battery is almost empty, the
battery status indicator flashes orange
(Fig. 2).
- When the product is charging, the battery
status indicator flashes green (Fig. 3).
- When the battery is fully charged, the
battery status indicator lights up green
continuously.
Note: After approx. 30 minutes, the light
goes out automatically.
Charging
Charge the product before you use it for the
first time and when the battery status
indicator indicates that the battery is almost
empty.
Charging takes approx. 8 hours.
- Charging or using the product at
temperatures below 40 °F (4.5 °C) or
higher than 95 °F (35 °C) adversely
affects the lifespan of the battery.
- If the product is subjected to a major
change in temperature, pressure or
humidity, let the product acclimatize for
30 minutes before using.
1 Make sure the product is switched off.
2 Insert the small plug into the product and
put the power plug in any 120V AC outlet
(Fig. 4).
3 After charging, remove the power plug
from the wall outlet and pull the small
plug out of the product.
Note: An adapter plug may be necessary for
cord usage in some foreign countries. Use