Philips Norelco Bodygroom 3000 Serie Manual De Instrucciones página 5

2 Press the on/off button to turn on the
product.
3 Stretch your skin taut with your free hand
(Fig. 13). Gently press the shaving unit to
skin and move it slowly and smoothly
against the direction of the hair growth
(Fig. 14Fig. 15).
- Do not press too hard. Too much
pressure can distort the foil and cause
skin irritation.
- Make sure the shaving unit is always in
full contact with your skin.
- The shaver is bi-directional, which means
that you can shave by moving the
product up and down. Shave against the
hair grain for optimal performance.
4 Switch off and clean the product after
each use (see 'Cleaning').
Shaving with the back shaving
attachment
Note: The back shaving attachment is
suitable for both wet and dry use.
1 Press and hold the release button (1) and
open the back shaving attachment (2) in
the preferred setting.
2 Place the bottom of the product in the
lower part of the back shaving
attachment. Then press the top against
the top part of the holder until it locks
into place with a click (Fig. 16).
3 Press the on/off button to turn on the
product.
4 Shave your back by moving the back
shaving attachment up and down by its
handle (Fig. 17).
Note: For your ease of use, the back
shaving attachment can be folded to
different angles (Fig. 18). Use a smaller
angle to shave your lower back (Fig. 19).
5 To remove the product from the back
shaving attachment, pull the top of the
product towards you until it unlocks from
the holder (Fig. 20).
6 To close the back shaving attachment,
press and hold the release button (1) and
push the handle against the holder (2)
(Fig. 21).
Cleaning
Clean the product after every use.
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product.
Never dry trimmer or shaving foil head with
a towel, brush or tissue, as this may cause
damage.
1 Turn off the product.
2 Remove any trimming guard from the
product.
3 Rinse the back shaving attachment and
product handle under warm water and
wipe dry with a dry cloth.
4 Remove the shaving foil head by pulling
it off the product (Fig. 23).
- Hold the shaving foil head by the plastic
housing only.
5 Rinse the shaving foil head with warm
running tap water (Fig. 24).
6 Allow the shaving foil head to air dry
completely.
- Never dry trimmer or shaving foil head
with a towel, brush or tissue, as this may
cause damage.
7 Rinse the hair chamber under warm
running tap water to remove any residual
debris (Fig. 25).
8 Reattach the shaving foil head by
snapping it back onto the product (Fig.
26). You will hear a click.
Storage
- Be sure the product is switched off.
Remove the power cord from power
outlet and the product before storing it in
a safe, dry location where it will not be
crushed, banged, or subject to damage.
- Do not wrap cord around the product
when storing.
- Store cord and other accessories in a
safe location where these will not be cut
or damaged.
- Do not place or store the product where
it can fall or be pulled into a tub or sink,
water or other liquid while plugged in.