Rubi 54999 Instrucciones Originales página 7

The speed of cut and the blade quality could change the blade's
trajectory. In this case the laser trace will not coincide with the final cut.
Adjust the tile as need.
Cut the tile and switch off the laser device (fig.6).
Switch off the laser device when not using it. You will improve bat-
teries life.
3.INSTALLATION
Laser device:
Switch off the Device before any manipulation
Tool for batteries substitution is not included (Screwdriver PH 1).
Remove the screws, washers and flat nut as shown in the picture (fig.2).
Insert batteries as shown in point 4.
Check device function. Switch in and off the device.
Fix the device on the machine as shown in following picture. Fix both
screws slightly (fig.3).
Place the blade as shown in following picture.
Switch on the laser device and move sideways until the trace coincides
with the blade's position.
Fix firmly one of the two screws and switch off the laser device (fig.4).
Next, place the blade at the end of the cut capacity of the machine.
Switch on the laser device and adjust the position of the laser devi-
ce (moving around the fixed screw) until the trace coincides with the
blade's position.
Fix firmly the second screw (fig.5).
Check that the adjustment is ok, by moving the blade along its trajec-
tory. The laser trace must coincide with the blade all the time.
Spirit level:
Clip the level on the holes by pressing slightly (fig.1,2).
Be careful when fixing the level, clips can be broken.
Once fixed, do not try to remove or to manipulate. It can be broken.
In case the machine is not ready to install the kit, proceed as indicated:
Laser device:
1. Make 2 holes of Ø5 mm (C) at 35 mm (A) of each and centred to the
blade position (fig.B-C).
2. B dimension should be minimum 75 mm and must respect the 5 mm
of the dimension D. (fig.B-C).
7.