Using Your Appliance - universalblue UHALOGEN1200-19 Manual De Instrucciones

3. ASSEMBLY
Assembly the heater body to the base following the instructions below:
 Insert the heater cable into the center hole and place it in the groove in the center
of the back of the base.
 Fit the body correctly in the base's grooves.
 Fix the body to the base with the nuts provided (2 nuts).
4.

USING YOUR APPLIANCE

Note：It is normal when the heaters are turned on for the first time or when they are
turned on after having been used for a long period of time the heaters may emit some
smell and fumes.This willdisappear when the heater has been on a short while.
Before putting the appliance into operation, choose a suitable place for the heater,
taking into account the previous safety instructions.
Unwind the power cord and plug it into the power outlet. Check that the output has at
least 10 amp current load capacity.
Before plugging in, turn all switches to the OFF position.
Then plug in the appliance making sure that the plug is correctly inserted to avoid
overheating or a malfunction of the appliance.
Select the desired operating power: 400W-800W-1200W.
Oscillation button: Press the oscillation button to oscillate the heater. Press again to
stop the oscillation.
Always make sure that the power cord can move freely while in oscillation mode to
avoid damage to the appliance.
Mid tube
Mid tube + upper tube
Mid tube + lower tube
All tubes
400W
800W
800W
1200W
13