Installation; Before Using Your Refrigerator - Sharp SJ-PX830F Manual De Manejo

Installation

1
Keep adequate ventilation space around the
refrigerator.
• The picture shows the minimum required space
for installing the refrigerator. The measurement
condition of energy consumption is conducted
under a different space dimension.
90mm
60mm
1028mm
• By keeping greater space, the refrigerator may
consume a less amount of power consumption.
• If use the refrigerator in the smaller space
dimension than pictured above, it may cause
temperature rise in the unit, loud noise and failure.
Overall space required in use
1432 mm
2
Use the two front the adjustable feet to place the
refrigerator flatly and firmly on the floor.
EN-3
50mm
846mm
Adjustable foot
3
Use the adjustable feet when right and left doors are
not properly aligned.
When the left door are
raised.
Lower the foot
at right side.
• Turn the adjustable feet until the opposite foot is
slightly off from the ground.
4
Connect the appliance via a correctly installed socket.
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
• When you insert the power plug with the door opened,
door alarm sounds but it is normal. This sound stops
after closing the door.
Four casters are located on the bottom
of the refrigerator .
• The casters allow the refrigerator to
move back and forth.

Before using your refrigerator

• Clean the inside parts with a cloth soaked in warm
water.
• If you use soapy water to clean, wipe it off thoroughly
with water.
Free standing type
When the right door are
raised.
Lower the foot
at left side.
Casters