easyGO Nino Manual De Instrucciones página 14

11.Manual
12.Backrest lock
13.Shoulder strap guide
14.Lap strap guide
15.Strap tension adjuster
16.Strap tension adjuster axis
17.Headrest
18.Shoulder strap slot
19.Baby insert
20.Harness belt buckle
21.Strap length adjuster
22.Seat recline adjuster
23.Harness length adjuster
24.Adjuster cover
25.Buckle cover
26.Shoulder strap pads
27.Shoulder strap
28.Shoulder strap guide
INSTRUCTION MANUAL
CAR SEAT INSTALLATION
WARNING! This seat can be installed only in
passenger seats facing forwards.
WARNING! Never install the seat in a
passenger seat equipped with a front airbag
due to the risk of serious injury or even death.
1.Seat installation for group I (children
weighing 9-18 kg) with 3-point car seat
belt.
Recline the seat to maximum (see: "Seat
recline adjustment").
Pull out the bottom backrest lock and push
the backrest forward (fig. 1). Lead the car
EN
seat belt between the seat's backrest and
shell and lock it in the appropriate buckle
(fig. 2). Open the shoulder strap guide (the
one closer to the buckle) and the harness
tension adjuster cover (fig. 3). Run the
shoulder strap through the open guide and
the lap strap through lap strap guides and
under the tension adjuster cover (fig. 4).
Tighten the straps in the buckle and close
the shoulder strap guide and tension adjuster
cover (fig. 5). Make sure that the tension
adjuster is properly closed. You should hear
a characteristic "click" (fig. 6). Adjust the
shoulder strap to have it running though
the middle of the upper seat shell, push the
backrest back into the shell, and push in the
lock (fig. 7). Pull out the upper lock partially
and adjust the shoulder strap to have it
running above the upper lock (fig. 8). Push
the upper lock all the way back inside (fig. 9).
2.Seat installation for group II (children
weighing 15-25 kg) with 3-point car seat
belt.
Before installation, remove the safety
harness together with covers and the baby
insert (see: "Safety harness removal") (fig.
10).
Pull out the shoulder strap guide in the lower
headrest (fig. 11), run the strap through it,
and push it back in (fig. 12). Place your child
in the seat and lock together with the seat
in the appropriate buckle (fig. 13, 14). Make
sure that the lap strap is as low above the
hips as possible and that the shoulder strap
is halfway between the child's shoulders and
neck (fig. 15). Tighten the strap.
3.Seat installation for group III (children
weighing 22-36 kg) with 3-point car seat
belt.
14