easyGO Nino Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
Adjust the headrest height to the child's
height (see: "Headrest height adjustment")
(fig. 16).
For further installation, see instructions for
group II (point 2).
USING INSTALLED SEAT FOR GROUP I
(children weighing 9-18 kg)
1.Adjusting the length of 3-point car seat
harness.
To loosen the harness, press the strap length
adjuster button and pull shoulder straps
downwards (fig. 17). Warning! Do not pull by
the strap pads.
2.Headrest adjustment.
To adjust the headrest, pull the lever in the
rear part of the headrest and set the desired
position (fig. 18). For group I, the headrest
adjustment mechanism is integrated with
the shoulder strap adjustment mechanism
and has 5 points. When the safety harness
is removed and the seat is used for groups
II and III, the headrest gains 4 additional
adjustment points. Make sure that the
headrest is adjusted appropriately to your
child's head.
3.Seat recline adjustment.
The seat has 5 points of recline adjustment.
To adjust the recline point, pull the lever
under the front part of the base and recline
the seat. You should hear a characteristic
"click" when you properly lock the seat in the
given position (fig. 19).
4.Securing the child with 3-point harness.
Loosen the straps according to point 1
above. Unfasten the middle buckle and
disconnect the shoulder straps (fig. 20).
Move the shoulder straps to the sides
and place your child in the seat (fig. 21).
Reconnect the shoulder straps and slide
them into the middle buckle (fig. 22). Adjust
headrest and shoulder straps to appropriate
height (fig. 23). Tighten the straps by pulling
on the length adjuster band (fig. 24). Make
sure that the harness is tight, but not too tight
to prevent the child's discomfort.
REMOVING 3-POINT SEAT HARNESS
AND REMOVING THE UPHOLSTERY
Recline the seat to maximum (see: "Seat
recline adjustment"). Pull out the bottom
backrest lock and push the backrest forward
(fig. 1). Loosen the straps by pressing the
strap length adjuster button and remove the
shoulder straps from the metal buckle in the
bottom part of the backrest (fig. 25). Pull
out the shoulder strap axle (fig. 26) and pull
out the shoulder straps from the slots in the
backrest (fig. 27). Lift the upholstery and slide
the strap locking buckles though the slots in
the seat (fig. 28). Remove the crotch strap
with the middle buckle by leading the locking
buckle through the slot in the seat (fig. 29).
After removing the 3-point harness, you can
remove the upholstery (fig. 30).
To put the upholstery and harness back in
place, perform the actions presented above
in reverse order.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido