easyGO Rotario Manual De Instrucciones página 14

13.Compartment
14.ISOFIX connector retract loop
15.ISOFIX connector
16.ISOFIX connector release button
17.Support leg adjustment button
INSTRUCTION MANUAL
1.Seat installation for group 0+/I (children
weighing 0-18 kg) with ISOFIX connectors
and support leg.
WARNING! Never install the seat in a passenger
seat equipped with a front airbag due to the risk
of serious injury or even death.
Before installation, make sure that the
passenger seat is equipped with ISOFIX
connectors.
Unfold the support leg until it locks automatically
(fig. 1A). Press the ISOFIX connector release
button and pull the loop in the rear of the seat
to pull out the ISOFIX connectors (fig. 1B, 1C).
Place the seat in the back passenger seat and
push the extended ISOFIX connectors into
the seat tethers until you see green indicators
on the connectors (fig. 2A). You should hear a
characteristic "click" when done properly (fig.
2B). Press the support leg length adjustment
button and pull it out until it rests firmly on the
floor (fig. 2C). The support leg lock indicator
must be all green (fig. 2D).
2.Taking the car seat out of the car.
Press the support leg length adjustment button
and push it all the way inside (fig. 3). Each
ISOFIX connector has a green indicator and a
red release button. Push them towards each
other in order to release the connectors (fig. 4).
Next, press the ISOFIX connector release button
in the front part of the seat and slide the ISOFIX
EN
connectors inside the seat base.
3.Headrest adjustment.
The headrest has 7 points of adjustment. Pull
the lever in the top part of the headrest and set
the headrest to the correct shoulder strap height
position (just above the child's shoulders) (fig.
5). The shoulder strap adjustment mechanism is
integrated with the headrest height adjustment
mechanism.
4.Seat recline adjustment.
The seat has 7 points of recline adjustment.
You can adjust it with your child in the seat. For
children aged 0 – 6 months, recline to maximum
and always use the insert for babies to ensure
proper spine support when the child is sleeping.
To adjust the recline point, pull the lever in the
front seat part and push the base (fig. 6).
5.Seat rotation.
The seat revolves to 360 degrees. This function
makes it much easier to place the child in the
seat as you can rotate the seat to face the car
door. It also comes in handy during stopovers
parking.
WARNING! When the car is driving, the seat
must be facing either backwards for group 0+
(children weighing 0 – 13 kg) (fig. 7) or forwards
for group I (children weighing 9 – 18 kg) (fig. 8).
Before you start driving, make sure that the seat
is locked into one of these positions.
WARNING! Never use the seat facing forwards
for children lighter than 9 kg.
To rotate the seat, push the revolving
mechanism button in the front part of the seat's
base and turn the seat to the desired position
(fig. 9).
6.Adjusting the length of 3-point car seat
harness.
14