easyGO Rotario Manual De Instrucciones página 15

To loosen the harness, press the strap length
adjuster button and pull shoulder straps
downwards (fig. 10). Warning! Do not pull by the
strap pads.
7.Securing the child with 3-point harness.
Loosen the straps according to point 1 above.
Unfasten the middle buckle and disconnect the
shoulder straps (fig. 11). Move the shoulder
straps to the sides and place your child in the
seat. Reconnect the shoulder straps and slide
them into the middle buckle (fig. 12). Adjust
headrest and shoulder straps to appropriate
height (fig. 13). Tighten the straps by pulling on
the length adjuster band. Make sure that the
harness is tight, but not too tight to prevent the
child's discomfort.
8.Baby insert.
The seat has an insert for the comfort and safety
of babies. The insert is an important element
and determines the child's safety, so you should
always use it according to this manual.
The insert is for children weighing up to 13 kg.
For children weighing under 5.5 kg, do not use
the insert without its foam part.
When using the insert, make sure that the
shoulder straps are in the lowest point.
Do not use the foam part of the insert for
children weighing over 13 kg. If you want to use
the insert for heavier children, remove the foam
part from the pocket in the rear part of the insert
(fig. 14).
15