RISCO Group watchU Guia De Inicio Rapido página 2

45° angle Mounting (Left side mounting)
a. Open knockouts on external base (Figure 3)

L1, L2: Left mounting knockouts

T3: Left tamper knockout

W5 / W6: Wire entry knockouts
b. Remove tamper spring.
c. Replace tamper bracket (Item 1) with
supplied flat tamper bracket (Item 2).
Item 1
d. Insert Tamper lever B onto T5 and T3 and
secure screw A (Figure 3).
4. Insert external wires through external base W2,
W3 (Flat Mounting) or W5, W6 (Left side
mounting) (Figure 3).
5. Secure external base to the wall.
6. Insert external wires and tamper wires through
internal base (Figure4).
7. Secure internal base to external base (lock I1,
Figure2).
8. Close the front cover (Lock C1, Figure1) after
wiring and setting DIP switches.
9. Walk test the detector.
Note:
For 45° right side installation use the equivalent units on the external base as follows:
Knockouts Description
Mounting Knockouts
Tamper spring knockouts
Tamper screw anchor
Wiring Knockouts
Changing Back Tamper position
The back tamper is by default secured on the right
side of the internal base (rear view). If you wish to
move it to the left side (rear view), do the following
(Figure 5):
1. Remove tamper screw 1 in order to release
the tamper from position 7.
2. Ensure tamper spring 2 rests over tamper wire
base 4.
3. Ensure plastic tamper bracket 3 rests over
both 2 and 4.
4. Secure tamper screw 1 into 3 over position 6.
Notes:
1. Verify that you hear a "Click" when attaching the tamper spring to the wall.
2. For pole installation, the tamper can be moved to the bottom right-hand side of the internal base.
Item 2
2
T1
T3
L1
Tamper
Lever
B1
B
W5
W6
A
W3
L2
B4
Figure 3
Figure 4
Left
L1, L2
T1,T3
T5
W5, W6
Left Side
Tamper
6
3
1
4
2
Figure 5
T5
T6
T4
T2
R1
(not visible)
B2
W9
W2
R2
(not visible)
B3
Right
R1, R2
T2,T4
T6
W7, W8
Right Side
Tamper
7
5