Human Touch pc300 Manual De Instrucciones página 4

get ready
UNPACK THE BOXES
Chair frame
Body pad
Headrest frame
ATTACH THE FOOTREST FRAME
1. Remove the two screws from the footrest frame.
2. Insert the ends of the footrest frame into the chair frame (Fig. 1).
3. Using a Phillips-head screwdriver, replace the two screws to secure the footrest frame (Fig.2).
Footrest frame
Fig.1
humantouch.com
Head pillow
Footrest frame
Fig.2
4
Your Human Touch Perfect Chair
®
the backrest and footrest frame, body pad, and head pillow, and you're done!
ATTACH THE RECLINE ACTUATOR
1. Align the mounting point on the recline actuator with the corresponding bracket in the center of the footrest
frame, then insert the hinge pin through the bracket (Fig.3).
2. Install the cotter pin on the end of the hinge pin (Fig.4).
Hinge pin
Fig.3
SECURE THE CANVAS AROUND THE FOOTREST FRAME
1. Pull the canvas firmly toward the footrest (Fig.5).
2. Wrap the two upper flaps around the footrest frame, then
secure then to the canvas using the hook-and-loop
fasteners (Fig.5).
3. Pull the canvas firmly toward the footrest, wrap the end
flap around the footrest frame, then secure the flap to
the underside of the canvas using the hook-and-loop
fasteners (Fig.6).
4. Pull firmly outward on the two side flaps, wrap them around
the footrest frame, then secure the flaps to the underside of
the canvas using the hook-and-loop fasteners (Fig.7).
End flap
Fig.6
requires some simple assembly. Just attach
®
Cotter pin
Fig.4
Upper flap
Fig.5
Side flap
Fig.7
5 5