ASSEMBLY INSTRUCTIONS
Step 1:
Mark wall for vanity placement and note the location of the
water supply lines and drain on the back panel of vanity.
Step 2:
Move vanity (B) into proper place against the wall.
Step 3:
Install faucet, drain and supply lines (none included) to
vanity top (A) according to the instructions supplied with
those items.
v
1
v
2
B
v
3
A
3
ASSEMBLY INSTRUCTIONS
Step 4:
The vanity comes with the knobs pre-assembled to the inside
of drawers and doors. To remove the knob, unscrew the bolts
located on the front of the drawers and doors. Re-install the
knobs to the front of the drawers and doors with the same
bolts.
Step 5:
In case of uneven floors, floor levelers are provided at the
bottom of the vanity. If necessary, adjust floor levelers by
hand to correct tilting and/or level doors.
Step 6:
To mount the backsplash (C) to the wall, apply a thin bead
of silicone compound (not included) to the unpolished back
side and bottom of the backsplash (C). Position backsplash
(C) as shown onto vanity top (A) and against the wall. Clean
any excess silicone compound before allowing to dry.
v
4
v
5
v
6
C
Silicone
UP
A
4