Cleaning/Maintenance; General Cleaning And Maintenance Work; Changing The Blade - Grizzly Tools ERM 1846 GT Traducción Del Manual De Instrucciones Original

GB
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.

Cleaning/Maintenance

Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade.
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
General Cleaning and
Maintenance Work
Do not hose down the lawnmow-
er with water. This would result
in the danger of an electric
shock and the appliance could
be damaged.
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
76
worn or damaged parts. Check that
all nuts, bolts and screws are sitting
firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.

Changing the Blade

Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance,
it must be replaced (see "Replacement
parts/Accessories").
1. Turn the equipment over.
2. Use sturdy gloves and hold the blade
firmly (25). Turn the blade screw (26)
anticlockwise off of the motor spindle
using a screwdriver.
3. Install the new blade in the reverse
order. Ensure that the blade is posi-
tioned correctly and the screw tight-
ened firmly.
Storage
In order for the device takes up less
space, loosen the two star knob
nuts (3) at the bow-type handle (1)
and remove the two star knob nuts
and screws (
(4). Now the bow-type handle (1)
and the lower bar (4) can be col-
lapsed together. Make sure that the
cable is not clamped.
6) on the lower bar