Cleaning And Care - CAPITAL SPORTS Pacemaker X55 Manual De Instrucciones

Folding/Unfolding and Transport
• Folding: First, lift the back part of the frame board with your hand till you hear a light sound, which me-
ans the folding system has been locked. Running board can't be turned to the opposite direction now.
• Unfolding: Place the folded treadmill in a spacious area. Then pull down the footplate till it is unlo-
cked. Please stand back for more than 1.5 meters and release it, then it will open automatically.
• Transport: Carefully lift the treadmill at the rear roller area, grasping the two side end caps, and roll
the treadmill away.
General Cleaning
Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge and frame. A
mild soap and water solution along with a nylon scrub brush will clean the top of the textured belt. This
task should be done once a month. Allow to dry before using. On a monthly basis, vacuum underneath
your treadmill to prevent dust building up. Once a year, you should remove the black motor shield and
vacuum out dirt that may accumulate.
General Care
Check parts for wear before use. Always replace the mat if worn and any other defective parts. If in
doubt do not use the treadmill and contact our helpline. TAKE CARE TO PROTECT CARPETS AND
FLOOR in case of leakages. This product is a machine that contains moving parts which have been
greased / lubricated and could leak out.
Belt/Deck/Roller Lubrication
The mat/deck friction may play a major role in the function and life of your treadmill and that is why
we recommend you constantly lubricate this friction point to prolong the life time of your treadmill. You
should apply the lubrication after approximately the first 40 hours of operation. We recommend lubrica-
tion of the deck according to the following timetable:
• Light use (less than 3 hours per week) every 6 months.
• Medium use (3-5 hours a week) every 3 months.
• Heavy use (more than 5 hours per week) every 6-8 weeks.
Procedures for lubricating
Use a soft, dry cloth to wipe the area between the belt and deck. Spread lubricant onto the inside
surface of belt and deck evenly (make sure the machine is turned off and power is disconnected). Peri-
odically lubricate the front and rear rollers to keep them at there peak performance. If you want to check
the running mat for proper lubrication: Disconnect the main power supply. Fold the treadmill up into the
storage position. Feel the back surface of the running mat. If the surface is slick when touched, then
no further lubrication is needed. If the surface is dry when touched, apply a suitable silicone lubricant.

Cleaning and Care

17