Troubleshooting - CAPITAL SPORTS Pacemaker X55 Manual De Instrucciones

Belt Adjustment
Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth, stea-
dy running surface. Adjustment must be made from the right and left rear roller in order to adjust tension
with the Hexagonal Wrench provided in the parts package. The adjustment bolt is located at the end of
the rails as noted in diagram below:
Tighten the rear roller only enough to pre-
vent slippage at the front roller. Turn both
the right and left bolt clockwise reasona-
bly and inspect for proper tension. Do not
overtighten; over tightening will cause belt
damage and premature bearing failure.
When an adjustment is made to the belt tension, you must also make a tracking adjustment to compen-
sate for the change in belt tension.
Belt Tracking Adjustment
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some belts to
drift near one side while the belt is running with no one on it. After a few minutes of use, the belt should
have a tendency to centre itself. If during use, the belt continues to move toward one side, adjustments
are necessary. The procedures are as below:
• First set speed at lowest position.
• Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by Left bolt Right bolt using 6mm
Hexagonal Wrench, until the belt is centered itself; if belt shifts to left, tighten the left bolt and loosen the
right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When adjusting the belt using the
6 mm Hexagonal Wrenches, it is important to adjust the belt in half turn increments. Over adjusting the
belt can cause damage to the mat.
Before attempting any work on the treadmill, ensure that the power is off and the plug is removed from
the power point. Do not use extension leads as it may lead to power decrease and failure.
E1: No feedback from controller or speed sensor
• Check the condition of cables and ensure that all plugs are connected between the motor controller
and display.
• Check that the speed sensor and magnet are in correct alignment and that there are no obstructions
on the magnet. (The magnet can be found on the front roller near the motor belt).
• If the running belt moves then displays the E1 error replace the speed sensor.
• If the running belt does not move replace the controller.
18

Troubleshooting