Assembling Your Carpet Washer; Important - Vax DualPower PRO ADVANCE W85-PL-T-E Manual Del Usuario

Assembling your carpet washer

Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/rugs/upholstery gently rub with the dampened cloth. Wait
ten minutes and check for colour removal or bleed with a white paper towel or cloth. If your carpet has more than one colour, check all colours. Test your carpet/rugs/
upholstery – Run the carpet washer over a small hidden area. If no pile distortion occurs continue cleaning. When cleaning an entire room, move furniture out of the area to
be cleaned. If the furniture cannot be moved, place aluminium foil or wax paper under the legs. This will prevent wood finishes from staining your carpet. Pin up furniture
skirts and curtains. When using the carpet washer, basic safety precautions should always be observed and don't over saturate your carpets. Only use Vax carpet solution.
Using other solutions may cause excess foaming and will invalidate your guarantee. The clean water tank should only be filled with warm water (max 40'C). Filling the
clean water tank with hot/boiling water will damage your machine and invalidate the guarantee. This is a powerful carpet washer, before plugging in make sure all controls
1
Stand the base of carpet
washer on the floor in the
upright position.
4
Slide SpinScrub tool holder
over and down handle.
6

IMPORTANT

!
Carpets should be dry vacuumed thoroughly before washing
are turned off also hold carpet washer firmly when starting and during use.
2
Turn handle lock dial
clockwise to lock in position.
5
Line up SpinScrub tool with
holder, slide tool down holder
and into place.
!
3
Tilt clean water/solution
tank and line up onto carpet
washer. Push tank back until
it clicks into place.