Using Channel Scan; Saving Channels To Memory; Deleting Channels From Memory; Changing Uic Mode - Unlden Wham X4 UM525 Manual De Instrucciones

Using Channel Scan

Hold down STEP/SCAN for about 2 seconds. The radio
scans all channels stored using the memory feature,
starting with the lowest channel number to the highest.
The channel numbers appear on the display.
Notes:
• TRI appears and the radio activates Triple Watch
when channel scan is active. During channel scan, the
radio automatically checks Channel 16 and Channel 9
every two seconds.
• Hold down 16/9/TRIPLE WATCH to take the radio out
of Triple Watch mode. The radio continues to scan.

Saving Channels to Memory

Briefly press MEM/UIC. The displayed channel is saved to
the radio's memory. Once a channel has been programmed
into memory, MEM appears on the display each time the
channel number appears. You can store any channel
except a weather channel into the radio's memory. Briefly
press MEM/UIC again to remove the channel from memory.

Deleting Channels From Memory

Tune the channel you want to delete then briefly press
MEM/UIC. MEM disappears.

Changing UIC Mode

Hold down MEM/UIC for about 2 seconds. The currently-
set UIC (USA, INT, and CAN) appears as you press MEM/UIC.

Selecting Menu Items

Briefly press SELECT/SCRAM to select menu items.

Displaying Time/Position/Course Info

Briefly press SELECT/SCRAM while a channel number
appears to display the following.
• Current Local Time
• Current Position (Latitude/Longitude)
• SOG (Current Speed Over Ground)
• COG (Current Course Over Ground)
Briefly press SELECT/SCRAM again to turn off display
mode. The current channel name appears.
16
Basic Operation