Programming A Fips Code; Using Auto Channel Switch - Unlden Wham X4 UM525 Manual De Instrucciones

5. Repeatedly press or
on Daylight Saving Time) or OF appears (to turn off
Daylight Saving Time) , then press SELECT/SCRAM.

Programming a FIPS Code

This option lets you add a FIPS code to the radio that will
in turn activate the radio's Specific Area Message
Encoding (SAME) weather alert system. You can program
up to 30 FIPS codes.
To enter a new FIPS code:
1. Briefly press MENU. MAIN MENU appears. Then
press SELECT/SCRAM.
2. Repeatedly press or
press SELECT/SCRAM.
3. Repeatedly press or
press SELECT/SCRAM.
4. Repeatedly press or
press SELECT/SCRAM.
5. Repeatedly press or
the FIPS code, then press SELECT/SCRAM to register it.
6. Repeat Step 5 for each number in the FIPS code.
After you enter the last number, YES appears.
7. Press SELECT/SCRAM to confirm the FIPS code you
entered. Otherwise, to cancel the FIPS code entry,
repeatedly press or
press SELECT/SCRAM.
8. Repeat Steps 4-7 to enter another FIPS code.
To change an existing FIPS code:
1. Repeat Steps 1-3 in this section.
2. Repeatedly press or
want to change appears, then press SELECT/SCRAM
again. EDIT appears. Press SELECT/SCRAM. The first
number of the FIPS code flashes.
3. Repeat Steps 5-7 in this section to change the FIPS code.

Using Auto Channel Switch

This option lets you turn automatic channel change on or
off during a DSC call. You might want to do this to prevent
the radio from automatically changing channels in an
emergency situation.
Using Setup Options
until On appears (to turn
until SETUP appears, then
until FIPS appears, then
until NEW appears, then
to select the first number of
until NO appears then
until the FIPS code you
21