Changing Output Transmit Power; Resetting The Microphone; Using Setup Options; Using The Directory - Unlden Wham X4 UM525 Manual De Instrucciones

Changing Output Transmit Power

Hold down MENU/H/L for about 2 seconds to change the
current output transmit power for the current channel from
high to low or low to high.
Note: Changing the output transmit power works only if it
is legal to do so on the current channel.

Resetting the Microphone

Cautions:
• Resetting the microphone does not reset the radio's
user MMSI.
• Resetting the microphone sets all features back to
their factory settings.
To reset the microphone, turn off the microphone, then
hold down MENU/H/L while turning on the microphone.

Using Setup Options

Using Setup Options
This section details the operation of the microphone's
setup options. You normally set these options the first
time you use the microphone.
Notes:
• The operation described in this section does not work
with Uniden's UM625 marine radio. See the UM625
Owner's Manual for more information about
connecting a WHAM x 4 microphone to that radio.
• See "Using System Options" on Page 23 for more
information about options you change more often.

Using the Directory

This option lets you set up a directory of other vessels
with DSC-capable radios. You can set up the microphone
so it displays another vessel's MMSI and name.
To add a new directory entry:
1. Briefly press MENU. MAIN MENU appears. Then
press SELECT/SCRAM.
2. Repeatedly press or
press SELECT/SCRAM.
3. Repeatedly press or
appears, then press SELECT/SCRAM.
18
until SETUP appears, then
until DIRECTORY
Using Setup Options