Samsung WF511AB Serie Manual Del Usuario página 17

Downloaded from www.Manualslib.com
WF511ABR-03010A_EN.indd Sec3:17 WF511ABR-03010A_EN.indd Sec3:17
2. Check the inlet hose to ensure a washer is inside each fi ll
hose.
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and attach each fi ll hose to the water valve. Make
sure the hose with Hot printed on it is attached to the HOT
faucet. Tighten by hand until snug, then two-thirds of a turn
with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an "nF" (no fi ll)
error can occur.
3. Turn on the "HOT" and "COLD "water supply and check the
water valve and the water supply connections for leaks.
4. Plug the power cord into a 3-Prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp
fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
5. Slide your washer into position.
6. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with
your washer.
When your washer is level, tighten the locking nuts using
the wrench or (-) fl athead screwdriver.
Your washer must be leveled on all four sides. A
carpenter's level should be used on all four corners of
your washer. We recommend you recheck your washer
after a dozen or so washes to makesure it's sitll level.
Avoid damage to the legs. Do not move
the Washer unless the Locking-nuts are
fastened to the bottom of the Washer.
manuals search engine
Cold Hot
Rubber Washer
Cold printed Hot printed
Locking Nut
Levelling Leg
installing your washer _17
2011-01-18 2011-01-18 4:15:08 4:15:08