Hyundai HYWE 15-54 PRO Manual De Instrucciones página 20

EN
Repair
service centre.
Tighten the unions; if the
problem persists, contact
an authorised service cen-
tre.
service centre.
Tighten the unions; if the
problem persists, contact
an authorised service cen-
tre.
Fault Abnormal noise
Cause Suction/delivery
are clogged or worn out.
Worn bearings.
The filter is dirty.
Extreme water temperature.
Repair
service centre.
service centre.
Remove and clean the filter.
Bring the temperature un-
der 50°.
Fault
Cause O-rings (water and oil) are
worn out.
Repair
service centre.
Fault
Cause Tanks empty.
Rod knob on high pres-
sure position.
Disconnected pipe in de-
tergent suction system.
Repair Replace oil with double fre-
quency that is suggested.
Fill the tanks.
Turn it to the low pressure
position.
Return it into position.
> REPAIRS - SPARE PARTS
For any problems not mentioned in this manual, or if
the machine breaks down, you are urged to contact
an Authorized After-Sales Service for the relative
repair or for any replacement of components with
original spare parts. Use exclusively original replace-
ment parts.
>
All our machines are subjected to strict tests and
are covered against manufacturing defects in accor-
dance with applicable regulations. The warranty is
effective from the date of purchase.
valves
- Parts subject to normal wear. - Rubber parts,
charcoal, filters and the accessories and optional
accessories. - Accidental damage, caused by tran-
sport, neglect or inadequate treatment, incorrect or
improper use and installation failing - The warranty
shall not cover any cleaning operations to which the
operative components may be subjected, such as
clogged nozzles and filter blocked due to limesto-
nes.
>
As the owner of electrical or electronic
equipment, the law (in accordance with
2003) prohibits you from disposing of this
product or its electrical / electronic accessories as
municipal solid waste and obliges you to make use
of the appropriate waste collection facilities.
The product can be disposed of by returning it to
the distributor when a new product is purchased.
The new product must be equivalent to that being
disposed of.
20
-