Rev-A-Shelf 548-10 Manual De Instrucciones

548-10 PULL OUT WIRE BASKET TEMPLATE
TOOLS REQUIRED:
TOOLS REQUIRED:
Template
Basket
Frame or Frameless Non Door Mount Installation
1)
Place template on desired cabinet wall and align bottom and side
(Note: fold or cut if needed). Tape in place. (Note: if placing on door
side make sure slides will not interfere with hinges.)
2)
Using a screw tip or awl, mark all (8) holes.
4)
Install slides to brackets using (4) #6 x 1/2" screws into small holes
of bracket. Open slide slightly until large hole is in line with front hole
location (#4 hole) to install front screw. Open slide completely to install
the back screw.
6)
Place basket keyholes over screws and lower basket until resting
on screws.
548-10 Pull-Out Wire Baskets
Template Instructions
ESTIMATED ASSEMBLY
TIME:
ESTIMATED ASSEMBLY
TIME:
15 MIN
15 MIN
PARTS LIST:
Plastic Brackets (4)
Slides (2)
#6 x 1/2" Screw (4)
#8 x 5/8" Screw (8)
3)
Remove template and install (4) plastic brackets at marked holes
with supplied (8) #8 x 5/8" screws. (Note: small hole on top of bracket
points toward cabinet opening.)
5)
Loosely install (4) M4 x 5mm Phillips round washer head screws to
slides.
7)
Tighten (4) M4 x 5mm screws and push basket into cabinet.
8)
Install (2) plastic clips.
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
CARE AND MAINTENANCE:
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
CLEAN WITH A DAMP CLOTH AND
AND WIPE PARTS DRY
WIPE PARTS DRY
M4 x 5mm Screw (4)
T-548-10-0417
T-548-10-TRI-0913