Krups FLF24F Manual De Instrucciones página 5

Ocultar thumbs Ver también para FLF24F:
Tabla de contenido

Publicidad

Thank you for choosing an appliance from the KRUPS range which is intended
exclusively for the heating of water.
CAUTION: the safety precautions are part of the appliance. Read them carefully
before using your new appliance for the first time. Keep them in a place where you
can find and refer to them later on.
Place your kettle and its base on a flat, stable, heat resistance surface. (1)
Before first use, rinse the inside of your kettle next fill it with cold water, boil and
empty the kettle, repeat this a couple of times.
Remove the lid by aligning the "" mark with the "open" position and lifting it off. (2)
To close the kettle, engage the lid, with the spout cover set back, by placing the ""
mark to "open" and turn it anti-clockwise to the "lock" position. The protective cover
will block off the pouring spout. (3)
With the kettle unplugged or removed from its base, fill it through the pouring spout
while pressing the thumb-release latch or via the open lid, to between the min and
max marks. (4)
Close the lid (3), and place the kettle on its base. (5)
Switch on by pressing the "I" switch. (6)
The kettle stops automatically as soon as the water boils. (7)
You can also switch the kettle off at any time during the heating process by pressing
the "0" switch. (8)
To pour, press the thumb-release latch under the handle. (9)
Empty the water from your kettle completely after each use.
To clean your kettle:
Unplug it or remove it from its base.
Leave it to cool, and then clean it with a damp sponge.
To clean the filter (depends on the model):
Clean the filter regularly. Rinse it in clean running water and using a soft, non-metallic
brush if needed.
Descale your kettle regularly.
Use:
1. a descaler specifically intended for PLASTIC kettles. Follow the manufacturer's
instructions closely.
2. or white vinegar. Pour 1/2 l of vinegar into the kettle. Leave it to work for one hour
without heating.
3. or citric acid. Boil 0.5 l of water. Add 25 g of citric acid. Leave it to work for 15
minutes.
Repeat if necessary.
USE
CLEANING
DE-SCALING
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Flf141Flf294Flf20134Flf39wFlf244Flf144 ... Mostrar todo

Tabla de contenido