MoistAir HD1407 Oak Manual Del Proprietário página 5

NOTE: The humidifier contains water bottles. The weight of the bottles in the front
of the cabinet may cause the front casters to sink deeper into the carpet. If this
happens, the water level will be higher towards the front of the humidifier, and
lower towards the back. The water level float (located at the rear of the cabinet)
may not sense the water so the flashing "F" will be displayed and the unit will not
energize. If this happens, the unit will need to be leveled in order for the humidifier
to be energized. To level the humidifier, place the included caster pads under the
front two casters of the humidifier only.
Moist air (humidity) produced will disperse into the whole house, but area closest
to the unit will have the highest humidity. If the unit is positioned close to a
window, condensation may form on the window pane. If this is not acceptable, the
unit should be repositioned in another location.
Step 2:
The humidifier should be positioned with the back (cord exit side), at least 2 inches
(5 cm) away from the wall or curtains. Air needs to enter through the louvers in the
rear panel in order for the humidifier to operate at peak efficiency.
Operating Tips for Best Performance
1. Position the humidifier at least 2 inches (5 cm) from any wall and away from
any heat registers.
2. Do not restrict airflow from entering or exiting the humidifier.
3. Use only EPA registered bacteriostat to reduce bacteria growth that may cause
odors and may be harmful to your health.
4. Perform regular cleaning as instructed in "Care and Maintenance" section of
this manual.
5. Replace the evaporative wicking filters at least once per humidification season
or more depending on water conditions in your area.
6. If unit is not level or bottles are not draining, install caster pads under front
casters to level unit.
Filling
WARNING: Disconnect power before filling, cleaning or servicing unit. Keep grille
dry at all times.
WARNING: To reduce the risk of fire or shock hazard, DO NOT pour or spill water
into control or motor area. If controls get wet, let them dry completely and have
unit checked by authorized service personnel before plugging in.
5