MoistAir HD1407 Oak Manual Del Proprietário página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Deactivation Procedure
To deactivate the "CL" function simply press and hold the power button for 5
seconds. "CL" will flash at the rate of 1 second on and 1 second off for a period of
2 seconds and then resume the display of room humidity.
Manual Dry Out
At the end of the
humidification season or if
you do not plan to run the
humidifier for one week or
more, a manual dry out
mechanism is provided to
completely dry out the
humidifier cabinet. To do
this, simply slide the float
retainer clip located at the
back of the humidifier
cabinet to the top of the
middle slot, as it is shown in the illustration. This will hold the float in an upward
position and the fan will run until you turn the power off.
NOTE: Be sure to reposition float retainer to the normal operating position (lowest
portion of the slot) before using the humidifier again. See diagram for proper
placement of the float retainer in the float retainer slot in the cabinet back.
Humidistat
The humidistat located on the power cord
senses the percentage of humidity in the
air. It causes the humidifier to cycle on
and off to maintain the selected humidity
SET point. The fan will turn on if the
"ROOM" reading falls 3% below the SET
point and will continue to run the humidifier until
a reading of 1% above the SET point is
achieved. The fan will turn off until the ROOM
reading falls 3% below the SET point again.
NOTE: Be sure the humidistat, which is located on the power cord,
is free from obstruction and away from any hot air source.
Replacement and Care of Filters
WARNING: To reduce the risk of shock or injury from moving parts, always unplug
humidifier before removing or replacing any parts.
CAUTION: To help reduce bacteria growth and keep maximum efficiency, the filter
should be replaced at least once per season, or more often under hard water
conditions. Use MoistAIR HDC12 replacement filter.
The filters may be rinsed periodically in clear water only. Take care not to damage
paper. To replace evaporative wicking filters in your humidifier, follow these
instructions.
Filter Replacement
1. Unplug humidifier before removing the filters. We recommend moving the
humidifier to an area where floor coverings are not susceptible to water
damage, i.e. kitchen or bath areas.
9

Publicidad

Tabla de contenido
loading

Productos relacionados para MoistAir HD1407 Oak

Este manual también es adecuado para:

Hd1409 brushed nickel

Tabla de contenido