MoistAir HD1407 Oak Manual Del Proprietário página 6

This humidifier is designed for use with
the two water bottles that are located
under the pivoting lid.
Open the pivoting lid of the humidifier.
Remove the water bottles by lifting them
straight up and out of the cabinet.
Notice the water bottles are designed as
right and left hand units. When refilling
the bottles ensure correct placement for
proper function.
The water bottles should rest in the front
of the cabinet. Each "Side-Fill Cap" must
be facing the rear of the unit.
CAUTION: Use only EPA Registered
Bacteriostat. Under no circumstances
should you use water treatment
products designed for Roto belt or
Ultrasonic humidifiers.
Each water bottle is designed with a "Side-
Fill Cap" and bottom valve cap. Before filling
each bottle check that the bottle valve cap is
on securely. To fill, remove the "Side-Fill
Cap" and place the opening under a water
faucet (the bottle should fit under a four-inch
clearance faucet). Fill with recommended
mixture of cold water and Bacteriostat (if
necessary) only. Solid debris could make the
valve leak. Install the "Side-Fill Cap" by twisting clockwise. Hand tighten only.
Note: Both bottle caps have rubber washers in them. Do Not Remove.
Check for possible leaks by performing the following:
1. Grasp bottle handle and hold the bottle upright over a sink.
2. Inspect the bottom valve for leaks.
3. Press up on the valve cap plunger for about one second to let out a little water.
4. Release the plunger.
5. Listen for air bubbles. Look for leaks around the"Side-Fill Cap".
6. If you hear air bubbles or see leaks, retighten the "Side-Fill Cap" and repeat
Steps 1-5.
6