PROTEOR 1P110 Instrucción De Montaje Y De Arreglo página 5

ASSEMBLING AND ADJUSTMENT INSTRUCTIONS
You have just bought a polycentric knee with hydraulic control of
walking rate.
This product was designed to satisfy your requirements for your va-
rious activities.
It is manufactured with processes used in aeronautics and so it is
efficient, light and resistant.
USE :
- For active patients or patients with low activity
- Up to 100 kg
- With a good muscular control
- Who expect to walAk smoothly and comfortably.
CONTENTS :
- 1 hydraulic knee 1P110
- 1 instruction sheet.
Upper link :
1K03-GR or 1K30-GR
1K160-GR
1K40-GR
1K20
Note : The instructions for assembling these compo-
nents must be carefully respected.
B : Theoretical rotation axis
Lower link
1G01 or 1G04
C : Screw tightening torque : 11 Nm
Finish
1G13 (complete or partial) : single-block cosmetic
1G28 and 1P11090
IMPORTANT INFORMATION
- Mount the tube on the stop of the bore bottom.
- Do not exceed the advised value for the tightening
torque of screw C because this could damage the
tube.
FOR HYDRAULIC KNEE 1P110
ASSEMBLING
: Plate with 4 holes and
36 mm centre distance
: Pyramid connector
: Connector for lamination
: Extension tube for knee
: 30 mm Ø tube
cover
: 2-parts cosmetic cover
CHARACTERISTICS :
- Control of the swing phase : extension return and
flexion are independent
- Adjustment of damping during extension
- Weight : about 870 g.
- Flexion : up to 145°
MATERIALS :
Titan, aluminium alloy of aeronautics quality, ...
1P11099-06/04
Page 5/13