HOW TO SET A THREE-HAND WATCH WITH CHRONO-
GRAPH (VD53, VD54, VD57, VD67)
TIME SETTING (VD54)
1) Pull out the crown so as to stop the second hand at the 12 o'clock
position.
2) Turn the crown to set the time.
3) Push the crown back in to position 1.
TIME/ DATE SETTING (VD53, VD57, VD67)
1) Pull out the crown to position 2.
2) Turn the crown unit the previous day's date appears.
Note:
Do not set the date between 9:00P.M. to 3:00 A.M. Otherwise the
date may not change properly. If it is necessary to set the date during
that time period, rst change the time to any time outside this period,
then set the date.
3) Pull out the crown to position 3. Advance the hour and minute hands
until the desired date appears.
turning the crown.
Note:
While setting the time, be sure to check that the correct A.M. or P.M.
period is set.
4) Push the crown back in to position 1.
HOW TO USE STOPWATCH
1) Press button A to start/ stop the stop watch.
2) Press button B to control the split time and reset.
STOPWATCH HAND POSITION ADJUSTMENT
1) Pull out the crown to position 3.
2) Press and hold buttons A and B at the same time for 2 seconds and
then release them.
where it was.
en set the hands to desired time by
e stopwatch hand moves back and returns to
39