Leatt HARD SHELL Manual De Instrucciones página 5

Neck Brace Integration
Back
8a. 8b. Brace over
Front
Back
8c. Brace under
Back
The FlipFit neck brace integration system is situated on the top front and rear of
the protector (8a). Remove the rear padding, push in for wearing your brace on
the outside (8b) or pull out to wear the brace on the inside(8c). When the brace is
in place, pull the BraceOn strap of the brace wing to attach it to the protector (8d)
Cleaning
DO NOT MACHINE WASH THE 5.5
DO NOT USE ANY BLEACH ON THE 5.5
LINE DRY, DRIP DRY OR DRY FLAT IN THE 5.5
DO NOT DRY CLEAN THE 5.5
DO NOT IRON THE 5.5
DO NOT USE ANY SOLVENTS ON THE 5.5
7
Back
Front
8d.
Back
Front
®
Copyright © 2013, Leatt Corporation
Wipe only with a soft cloth damped in gentle soap or mild detergent in cold
water, rinse by wiping with a soft cloth damped in cold water and dry with a soft
cloth. Common substances applied to this product (solvent, cleaners, hair tonics,
etc.) can cause damage that may be invisible to the user and compromise the
effectiveness/safety of your Leatt ® protector.
Always refer to the material content label on the protector. None of the materials
used in the construction of the product are known to contain anything that might
cause an allergic reaction or be dangerous to health.
Storage and transportation
Place on a clean, dry surface and store in a dry, well-ventilated environment
away from direct sunlight and extremes of temperature. Do not place heavy
objects on top of your 5.5 Chest Protector Pro HD.
The protection provided by your 5.5 should not be affected by non-extreme
ambient temperature and weather conditions.
Maintenance and Obsolescence
For maximum performance, your 5.5 Chest Protector Pro HD must be inspected
prior to each use. Stop using the protector if any components show signs of
damage or are worn, cracked, and/or deformed, or if the inside padding has
®
deteriorated. Leatt Corporation recommends that your 5.5 should be replaced
every three (3) years under normal use conditions.
Should you experience a collision or if your 5.5 or any component shows any
signs of damage, cracking, deformity and/or the inside padding is deteriorating,
return the product to the seller for inspection or destroy and replace it. Please
dispose of it in an environmentally-friendly manner.
Do not drill holes, paint, cut, heat, bend, apply decals or stickers, or make any
other modifi cations to the 5.5. Doing so may compromise the effectiveness and
safety of your Leatt ® product.
®
Copyright © 2013, Leatt Corporation
8