Saneo VT-C18 Manual De Instrucciones página 24

Control Panel
1. Cool : Press the "COOL" button to start the cooling function. Press the button again and
the cooling function stops. Please note that the cooling function is not operational
when there is no water in the water tank.
2. Off : When the air cooler is in stand-by mode, press the LOW/MIDDLE/HIGH buttons to
turn it on, and the OFF button to turn it off.
3. Speed (Low/Middle/High buttons) : The wind speed can be adjusted by pressing the
"Low", "Middle" or "High" buttons.
4. Swing : Press the "Swing" button to activate the oscillation function. Press the button
again and the swing function will stop.
Filling the water tank :
1. Open the top cover.
2. Fill the tank with clean water, making sure that the water level is always between the MIN and
MAX marks, without exceeding the MAX level indicated on the water level indicator at the bottom
of the front of the appliance.
3. After filling, close the top cover.
Note: To refresh the air more efficiently, you can fill the tank with chilled water.
The air cooler comes with 2 ice packs. Place the ice packs in the freezer for several hours, making
sure they are frozen. Then place them in the water tank before filling it with water so that it does
not overflow and so that the maximum level of the appliance is not exceeded. The temperature
inside the tank will drop below 8°C after about 10 minutes.
Use :
1. Fill the water tank (see paragraph "Filling the water tank" above).
2. Plug the appliance into an earthed wall socket.
3. Press one of the "LOW/MIDDLE/HIGH" buttons on the unit. Press the "OFF" button again to
switch the appliance to standby mode.
4. Please refer to the paragraph "Control panel" regarding the different functions of the air cooler.
OPERATING THE APPLIANCE WITHOUT WATER MAY CAUSE PERMANENT
DAMAGE TO THE APPLIANCE