Wiring Diagram - Acuity Brands LITHONIA LIGHTING QUANTUM ELM6 LED Instrucciones Para La Instalación

page 2
NOTE:
This unit should be mounted ONLY through a
pair of the preformed keyholes onto a 4" "OCTAGON"
junction box, or through a pair of the keyhole knockouts
onto a 4" SQUARE junction box.
IMPORTANT: Provide each unit with a single-phase AC
unswitched power supply from a 120 V or 277 V circuit used
for normal lighting.
IMPORTANT: The battery must be connected to the unit prior
to applying AC power. Battery damage will occur if the battery
is connected for longer than 24 hours without providing
continuous AC power.

WIRING DIAGRAM

(Some component locations may vary)
LAMP
BLUE (-)
YELLOW
(+)
CHARGER
BOARD
"READY" LIGHT
TEST SWITCH
BATTERY
CONNECTOR
(SINGLE POLE)
RED
BLUE
-
+
YELLOW
(+)
BATTERY
BLUE (-)
LAMP
INSTALLATION and WIRING
REMOTE
LAMP
(REM
Option
YELLOW (+)
only)
BLUE (-)
AC INPUT CONNECT
(ON MOUNTING PLA
ORANGE: 277V
BLACK: 120V
WHITE: NEUTRAL
NOTE:
Unused lead must be
properly insulated with wirenut
or other code-approved method
See Wiring Diagram. Route all leads through the center hole of the
mounting plate and use appropriate code-approved connectors,
capping unused leads. In Remote Enabled (REM) versions, if no
remote lamps are to be connected, the extra wire harness may be
discarded.
Using caution not to pinch wires or connectors dressed inside the
OR
junction box, secure the mounting plate to the junction box screws.
TE)
For increased security, additional screws are recommended.
To ensure proper engagement of the mounting plate latches to the
housing, DO NOT OVER-TIGHTEN THE SCREWS.
(REM
Option
only)
Connect the battery.
(REM
Option
only)
NOTE: