Publicidad
Idiomas disponibles
Idiomas disponibles
Remote Enabled Versions
Attach the free end of the security strap to the knob feature on the
right end of the mounting plate.
installation,
plug the lamp connectors together.
NOTE: Emergency lighting systems should be tested in accordance
with NFPA 101 or as often as local codes require, to ascertain that all
components are operational.
NOTE: Allow battery to charge 24 hours before initial testing, and 48
hours for full charge.
Normal Operation: When the unit is functioning properly, with power
applied to it, the "TEST" button will be illuminated red.
Manual Testing: Press the "TEST" button. It will remain illuminated
while the emergency DC lamps turn on.
INSTALLATION and WIRING
(REM Option)
:
If a remote lamp is included in the
(Fixture appearance may vary)
Housing attachment to mounting plate:
Make certain all wires and connectors are routed to avoid interference
with other components, and that the battery wires are within the
battery compartment. Align latch openings on underside of housing
with latch buttons on mounting plate. Firmly push housing straight
onto mounting plate, making certain all four latches are fully engaged,
and the housing is closely aligned to the mounting surface.
TESTING
page 3
Publicidad
