Installing The Toilet; Securing The Toilet - Glacier bay N2450E Guía De Uso Y Cuidado

Installation (continued)
3
Installing the wax ring
□
Turn the toilet bowl (B) upside down onto a towel or
cushioned surface. With the rounded (tapered) end of the
wax ring (CC) facing the toilet, place the wax ring (CC)
around the raised outlet ring of the bowl (B), and press
firmly enough so the wax ring (CC) adheres to the bowl (B).
If the supplied wax ring has a black cone extension, this
should be faced away from the toilet.
5

Securing the toilet

□
From the backside of the toilet (B), place the
plastic discs (DD) over the floor bolts (AA), noting
'this side up' on the top of the discs.
□
Tighten the floor bolt wing nuts (EE) onto the floor
bolts (AA) to secure the position of the plastic
discs (DD).
□
Place the bolt cap covers (FF) over the floor bolts
(AA) and snap into place.
4

Installing the toilet

□
Place the toilet bowl (B) over the toilet flange (1) in
alignment with the floor bolts (AA) so they protrude through
the slots on the base of the toilet bowl (B). Press down on
the toilet bowl (B).
NOTE: Remember to remove temporary plug from
the floor flange prior to placing the bowl.
6